Hi Walter thx for the fast Questions,i dont understand!?
u say
"Therefore you need a card < 64 GB once to pass this limitation. After initialising the camera you can run ML from your 128 GB card."
and then u say
"Therefore: No card with ML software on it -> ML is not running."
- and how i unstill ML,Clearly?
- Can i use then 8 or 16gb Card to install only ML and after that i can use my 128GB Card and ML is working???
My English is not well,maybee here is a German guy who can help me.
regards
You need to use your 8GB or 16GB card for the initial "install" of ML. The smaller cards are required for running the firmware update to set the camera bootflag (THIS IS NOT THE FIRMWARE UPDATE TO 1.0.4). From the instructions in the OP
"8. Start camera in M photo mode and run firmware update. THis will run the ML setup and make your card bootable too."
This is the update using 650D.104.installer.fir
After this initial update of the firmware to set the bootflag on the camera, you do NOT need to do a firmware update again. You can install ML on the 128GB and set the bootflag on the card using EOSCard or MacBoot. Put in the 128GB and ML will be loaded. Any card without ML on it and the bootflag (on the card) not set will not run ML.
To say it another way, there are 2 bootflags. One on the card and one on the camera. You only need to set the bootflag on the camera once and the SD card used to do that must be 32GB or smaller. After that is set, you must set the bootflag on each card you use. Put ML on larger cards and set the bootflag on the card using EOSCard or MacBoot. Your camera will run ML when that card is installed
If you set the bootflag on the card, you MUST have ML on the card or the camera won't appear to work.