Thanks, already tried that with formatting card in camera and in windows. Tried with two batteries. Do I supposed to get any message that firmware update was successful? It just shows Firmware loading, screen goes blank and blue led starts blinking every couple seconds.
The instructions aren't too clear.
On your first install you need to do the firmware update with the file named "5dc.111.card bootable.fir" in the root of the card
This makes your card bootable
next you have to do the firmware update with the "5dc.111.ML install.fir" file (as well as all the other ones needed for ML)
This installs the ML bootflag.
There is no message that it was successful. The blue light should come on steady - like the instructions say. Then you have to remove the battery to re-boot the camera.
Blinking light means something wasn't installed properly.
I'm not sure what the camera does if you do the upgrade firmware process with 2 fir files in the root of the card.
after copying all the files over there, I made sure there was only 1 fir file each time when I did the firmware upgrade process and it worked for me.