Hey guys!
Just joined the 50D club (400$). I have been reading this forum for 2 years now. I have been following the RAW development since the beginning. I read all about it.
My workflow so far: RAWanizer -> AE -> Premiere.
I love the image. I have to get used to image differences, exposing the RAW compared to 550d h.264.
! I think I noticed something interesting !
When importing the DNG's to AE CS6, everything works fine, Camera RAW works perfectly fine.
Then, when I put the footage in 32bit composition (23,976fps), it is usually scaled up/down, due to being 1584xXXX in size. 2:35 aspect ratio. Normal.
Everything was fine so far. Then, I did RAM Preview on full screen and noticed severe aliasing on the edges. I know what causes aliasing (line skipping and shit). Something was odd though. I went back to Camera RAW, and there was almost none aliasing in 100% or 200% preview.
I went back to my composition. When the preview (in normal workspace scenario) is set to "(76%)" or "fit up to 100%" or "fit" it causes aliasing WHICH IS THEN VISIBLE IN FULL SCREEN RAM PREVIEW.
When you switch it to 100% (too big for workspace window) and then go for full screen RAM Preview again THERE IS LESS ALIASING.
So to minimize aliasing in AE CS6, you have to have your preview on 100%. I tested it three times with different footage, same scenario everytime. It seems like Camera RAW preview is almost smooth, then AE goes apeshit with diagonals and sharp edges.
I change composition for 1920, then set 100%, then RAM Preview.
Anybody noticed this?
Peace.
P.S. Still waiting for faster card to try continuous shooting. Then will post some tests (not cats, I will try to edit something of value).