5D3. ML doesnt complete installation

[cappedup]

Hello there. Great site, great product. Ive seen it on a 60D. Very nice.

So I bought myself a 5D3 (in the US) and have not been able to install ML successfully.

I originally was trying on a 16gb eye-fi card but it would make the camera hang, in a battery pull way.

Ive just got myself a 8gb Sandisk SDHC and seemed to get closer, but not all the way.

I have done the following:

Cleared camera settings.
Formatted SD card in camera, low level.
Updated camera firmware from 1.1.3 to 1.1.3, just in case.
unzipped ML files and folders onto the SD card with 'in-laptop' card reader. Version from this link http://www.magiclantern.fm/forum/index.php?topic=2602.msg18197#msg18197
Inserted in camera and turned on.
Updated firmware again.
It  loads the firmware update program.
It runs the CF card test and SD card test.
Then nothing. Camera returns to shooting mode. No green screen.

Full battery, new camera. Nothing attached. Red blinking LED every 5 seconds.

Any ideas?

[cappedup]

Ahh, got it. Great.

Oddly it had loaded, without the green confirmation screen, and I don't think I was hitting the erase button firm enough to bring up the menu.

I'm right in saying there is no intervalometer support for the 5d3 yet?