HowTo? ETTR "Allow Clipping" be retained instead of forgotten? Feature req?

[l_d_allan]

6D 1.1.6 with Build June-19

I notice that the "Allow Clipping" shows up as an "Advanced ..." option for ETTR. Then it is "forgotten" when you shut down the camera. You have to enable "Allow Clipping" the next time you start ML and use ETTR.

Is this "as intended"? Seems like "Allow Clipping" isn't really all that advanced of a setting compared to some other choices. In any case, it seems it ought to be "sticky" and remembered from shut-down to re-start.  Or not?

Am I doing something wrong (again)? Is there a way to accomplish this?

If this setting isn't "sticky", can that be a Feature Request so that it is "sticky" and remembered?

Thanks.

[mothaibaphoto]

Then it is "forgotten" when you shut down the camera. You have to enable "Allow Clipping" the next time you start ML and use ETTR.

My camera keeps any settings, including "Allow Clipping". Check whether "autosave" enabled.