Trouble installing 2.3 RC2 on 60d

[MinusNothing]

Hi,

I have firmware 1.1.0 that I installed a while ago, but I get a flashing SD card when I try to install ML v2.3 RC2.

This install document says I need FW v1.1.0:
http://wiki.magiclantern.fm/install#step_1_preparing_your_camera

The install guide also says reinstall FW v1.1.0. However, when I try to get the FW from Canon, I can only download v1.1.1.

So, can I use v1.1.1, or do I need v1.1.0?

If it's v1.1.0, where do I get it?

Cheers,

[nanomad]

That documentation is for the stable release, not RC
You need 1.1.1 (as the downloads page says)

[MinusNothing]

That documentation is for the stable release, not RC
You need 1.1.1 (as the downloads page says)

OK thanks, problem solved...