Good morning a1ex, thanks for the reply!
I think you are right, it's likely a hardware issue. I gave the camera a brief round of fixes this morning with no success.
I'll give the autoexec a go, and then start planning for hardware repairs.
The error flag on the LCD screen I'm pretty sure just showed up randomly, and no batteries were taken out at the time. I just powered it down immediately for fear there was some power overload. But now I think it was just a last electronic gasp before the hardware went South.
My research indicates it's probably the DC Power PCB board (hopefully) Not an expensive part, but if not, then the it's the Main Logic Board.
Well thank you again A1ex (and the team) for the reply and the great software! Keep up the great work! I'll update the thread once I know more.
Best ~ MJ
I think you are right, it's likely a hardware issue. I gave the camera a brief round of fixes this morning with no success.
I'll give the autoexec a go, and then start planning for hardware repairs.
The error flag on the LCD screen I'm pretty sure just showed up randomly, and no batteries were taken out at the time. I just powered it down immediately for fear there was some power overload. But now I think it was just a last electronic gasp before the hardware went South.
My research indicates it's probably the DC Power PCB board (hopefully) Not an expensive part, but if not, then the it's the Main Logic Board.
Well thank you again A1ex (and the team) for the reply and the great software! Keep up the great work! I'll update the thread once I know more.
Best ~ MJ