Messages

Format card in cam.
Retry EOScard.
Delete contents from card (autoexec.bin, *.FIR, ML directory).
Copy extracted zip content (for 1200D) to card.
If you have another card (32 GB or less) you should go with this one.

Found on another forum that it was my built in sd reader the was not reading the vbr. used a usb reader and it worked great.
Thanks again!

Thank you all for the help. I was soo close before. But now I'm still stuck. I can't get the make_bootable.sh to run
I've installed cygwin. When I run the .sh in that console, it tells me I need to mount my sd card. I can't figure out how
I've tried the eoscard app but it says, "exfatVBR load failed" 
I'm using a class 10 64gb lexar

ok so I ran the 1200BOOT.FIR and it gave me a rom dump msg over my last picture and then a ""

But I cant find a ML menu. Tried the ml-setup.fir from a nightly build and it froze my camera saying there was no boot/firmware file

See reply #156

Thank you. Do I need to use the ML-setup.FIR from one of the other nightly builds? Do these two files first, the format and put on ml-setup.fir with the ML data files from this build?

Hey guys,

First off, THANK YOU for all the work in porting this.

However, I cant seem to get it to install. I've downloaded you most stable build from you link, formatted my card in camera, made sure firmware was up to date, put ML files on sd, but when I go to the update firmware screen to install ML, it tells me there is no FW on the card.

Using a lexar class 10 64 gb if it helps