Other thoughts:
The reason I was somewhat nervously pulling cards in and out was that the camera apparently did not boot up after I changed cards and this (see p.7 in my steps) resonates with msg on ML fb page -
The reason I was somewhat nervously pulling cards in and out was that the camera apparently did not boot up after I changed cards and this (see p.7 in my steps) resonates with msg on ML fb page -
QuoteEric J. Russell
Yesterday at 1:55pm
Two Identical SDXC cards. One boots ML fine, the other puts my 700D in a brickatose state that can only be broken by ejecting the SD card and pulling the battery in and out, and even then the brickatosing SD card can't be in the slot or else the camera stays dead.