Thank you very much! Works now.
- Welcome to Magic Lantern Forum.
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Duplicate Questions / Canon 550D boot flag
June 24, 2015, 02:04:00 PM
Hello!
Not sure if it's correct section but I will give it a try.
I just tried to install ML for the first time ever. Read installation manuals and etc. and tried to install ML on my Canon 550D. As it said in manual, I had to check my firmware version - I did. It was 1.0.9 as ML need but I still did upgrade firmware (just in case).. Formated card in camera and copied ML install contents to my SD card (Toshiba 16GB). Went to install ML and... got error: could not enable boot flag. Ok, as I read, I should use EOScard if it fails, also reformat SD card on PC first, then once again on camera. Did both. Still get that error.
Any ideas what I do wrong?
And sorry again if it's wrong place,
Thanks in advance.
Not sure if it's correct section but I will give it a try.
I just tried to install ML for the first time ever. Read installation manuals and etc. and tried to install ML on my Canon 550D. As it said in manual, I had to check my firmware version - I did. It was 1.0.9 as ML need but I still did upgrade firmware (just in case).. Formated card in camera and copied ML install contents to my SD card (Toshiba 16GB). Went to install ML and... got error: could not enable boot flag. Ok, as I read, I should use EOScard if it fails, also reformat SD card on PC first, then once again on camera. Did both. Still get that error.
Any ideas what I do wrong?
And sorry again if it's wrong place,
Thanks in advance.
Pages1