Messages

Rainless,

Thanks again for your insight. I guess I got lots of information to digest, yours was very relevant.

Andrew

Whilst the video records fine at 960x540, It will not record without the frame stopping error at 1280x720. Which I presume translates to it cannot write to the card fast enough. Unless there is another reason including set up on the canon firmware or the ML.

My card supposed to accept a write speed of around 55.4MB/s. Just wondering where the bottleneck might be.

This is the card I purchased:

http://www.amazon.co.uk/Transcend-Ultimate-Class-UHS-I-Memory/dp/B0085T0VXY/ref=cm_cr_pr_product_top


Andrew

Rainless,

Did I say I was a noobie.

Thanks for the good advice, Seems the files may well have been good. I'll read the ML user manual, slow down a little and take my time to work through any Issues.

Thanks again.

Andrew

I removed ML via the update firmware via canon interface.

Then followed Installation procedure from scratch, Updated to 4th April nightly build.

Recorded another file though this time I enabled mlv_playback as well as mlv-rec. I recorded a 30 second file. When I press canon preview It states preparing then display reads 'files ends prematurely during block header'

I'll try anything that won't brick my camera and should result in a resolution.

Is the latest nightly build proven to be working at least to record and playback?

Thanks again

Strange thing is the files are on my memory card once I connect to my PC but will not open.

In addition Adobe after affects will not open the file which is a *.RAW

Andrew

Correct.

Also when I press the ML menu button ( cannon trash) It states recording in progress. The red recording light on bottom right of camera is illuminated.

Andrew

HI,

I download the latest build which was April 2nd. I noticed the disable all modules was enabled by default.

I loaded the mlv_rec then set under Movie tab: RAW Video to 960x540. Got different results after 6 seconds I get frame skip but no file is saved. Another time instead of the red camcorder logo in rhe top right hand corner I get a green logo that seems to record for at least 30 seconds but no file on playback. So no file in ML up to this point is saved to the memory card.

Thanks for your help.

Andrew

Hi,

I'm a newbie to ML and have for the past few weeks been reading through the many threads.

I have the 650D and Installed ML however I'm having some Issues:

I purchased a Transend 90MB/s ultra 32gig USH-1 Write: 55,4MB/sec.

The only Module I have loaded is raw_rec.mo set initially set to 1280x720 these are my only settings in ML

Raw-Rec enabled

After about 10sec I get an error 'movie recording stopped automatically' nothing was saved to the memory card.

I then under Movie tab I reset the Raw video to 640x360 I do not get any error, however nothing again was saved to the memory card.

If I record with the canon firmware 1920x1080 @24  there are no issues.

I guess It could be the memory card or more likely be user error in the way of setup.

Any help in identifying the root cause of the issue would be greatly appreciated. Including cannon forware settings and also ML settings.

I guess If it's the card which I purchased from Amazon ( Not 3rd party seller) I'll dispatch it back to them.

Andrew