Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - cbgeebee

Pages: [1]
Tragic Lantern / Re: Tragic Lantern for 6D
« on: February 06, 2014, 09:11:06 PM »
Noted  ;)

Hadn't formatted card to exFAT, so will do so and try again.


Tragic Lantern / Re: Tragic Lantern for 6D
« on: February 06, 2014, 08:31:28 PM »
Quite weird because none of that is touched. Canon is writing the files and all we have for >30 mins is movie restart.

Did your card read in the camera after it didn't read in the macbook? Also... exfat + macos, any issues there?

- No, when I put card back in camera TL did not boot. On the macbook the card was showing up as "NO NAME" and there were no files at all.

Had to reformat the card and it works fine again now (without TL as already stated). Sorry needed to use it again, so not sure if I can remember anything else that might have been of use to you.

Tragic Lantern / Re: Tragic Lantern for 6D
« on: February 04, 2014, 10:04:47 PM »
Hi 1% & all the rockstar devs and supporters! ;)

Great work on TL so far - loving playing around with it. Peaking, Zebra, Magic Zoom & Audio Monitoring rock!

I had a couple of recent problems when testing TL on my 6D. I installed Jan 18 build about 10 days ago.

1. SD Card/30 Mins+ Recording Issue:
I tried recording for 32 mins continuously on to my 64GB San Disk Extreme Pro SD card, to test what would happen. It seemed to process ok (camera didn't freeze as Nov 30th build had done sometimes), but when I ejected my card and put into the card reader my macbook could no longer read the card.

2. Audio Recording - File Length Issue:
I had Canon audio enabled because my rode video mic was out of battery. However the rode was still connected via the minijack port. Result: the length of the associated separate .WAV file when imported into Premiere Pro was just over 6 hrs, irrespective of the length of the video clip taken. When the rode's battery was replaced, the problem disappeared. I know I could've just disconnected the mini jack, but thought this may be of interest.

For now I've scrubbed the 2 cards I was running TL off, as a safety measure, because I have to use the camera for video work and can't risk corrupting them.

Keep up the good work!

Pages: [1]