Messages

Check:

Card is bootable
ML autoexec.bin + support files(ml folder from camera/nighlty) are there

Also boot the camera without a card after removing/installing battery.

Yeah, booting without card got it working again. I'm a might confused on how to go about things now though... Do I take the nightly build autoexec.bin and ML folder, pair it with the new 2.0.2 ML FIR file and follow standard install?

I seem to have run into a problem.

My EOSM came with 2.0.2 factory installed. I downloaded the package from the link in the first post of this thread and then replaced the .FIR file with the one posted by 1% up above (at http://www.qfpost.com/file/d?g=fb5V0T8Wj) so it would work with 2.0.2, then followed standard installation procedures. All seemed to go well and the welcome screen came off. I restarted the camera and the welcome screen was still there so I restarted it again. It didn't start, and now whenever the power button is pressed, the card read light just rapidly blinks green and the camera does not turn on.

Is there something wrong with ML or did I do something stupid? And what (if anything) can I do to fix it?