Hi.
I'm not sure if i use this feature correctly.
when i enable shortcut key( only for ISO and K value, and I use manual focus, and disable follows focus ) on my T3i, I can change the ISO and K value without any problem, but once i press the shutter button half way, the shortcut key is toggled off( because you won't see +/- ISO and +/- K on the screen), you have to press Disp button on T3i to bring it back.
my question are :
1) Is this suppose to act like this ?
2) is there way to keep the shortcut key on screen even i press the shutter button halfway? because during the
video recording, sometime i press the shutter button to see my exposure meter , but i forget to press Disp
button to bring shortcut key back to screen , and if I try to change ISO by pressing Arrow button , it will
move the frame box , I have to press Disp button then Arrow button to change the ISO.
It's OK for me, because you can use one hand to press Disp Button the Arrow Key on T3i, but on 5DII the
toggle button is Picture Style button, so I have to use my left hand to toggle it. it's not so convenient
I'm using magiclantern-2011Dec22.550D.60D.600D.50D.500D on Canon T3i 1.0.1 firmware
it's same behavior when using Magic Lantern for 5D Mark II 2.3 RC1 on 5D2
I'm not sure if i use this feature correctly.
when i enable shortcut key( only for ISO and K value, and I use manual focus, and disable follows focus ) on my T3i, I can change the ISO and K value without any problem, but once i press the shutter button half way, the shortcut key is toggled off( because you won't see +/- ISO and +/- K on the screen), you have to press Disp button on T3i to bring it back.
my question are :
1) Is this suppose to act like this ?
2) is there way to keep the shortcut key on screen even i press the shutter button halfway? because during the
video recording, sometime i press the shutter button to see my exposure meter , but i forget to press Disp
button to bring shortcut key back to screen , and if I try to change ISO by pressing Arrow button , it will
move the frame box , I have to press Disp button then Arrow button to change the ISO.
It's OK for me, because you can use one hand to press Disp Button the Arrow Key on T3i, but on 5DII the
toggle button is Picture Style button, so I have to use my left hand to toggle it. it's not so convenient
I'm using magiclantern-2011Dec22.550D.60D.600D.50D.500D on Canon T3i 1.0.1 firmware
it's same behavior when using Magic Lantern for 5D Mark II 2.3 RC1 on 5D2