Hi all,
Hope this is ok to post here as it's not ML related as such.
I went to run a firmware update on my 5D iii the other day and it's stuck in a loop of trying to run the update. Always fails at 54% and only thing I can do is remove the battery. If i boot without card it just says it can't find the firmware file. If I boot with the card in then it goes to the firmware update screen and my only option is to select ok and let it try to update again but always fails at 54%.
I used a card that was formatted in the camera. Camera set to P with a full battery in.
Don't know if there's anything I can do to get it out of the loop and restored or if I'm going to have to get it repaired.
Anyone have any suggestions?
Thanks
Andy.
Hope this is ok to post here as it's not ML related as such.
I went to run a firmware update on my 5D iii the other day and it's stuck in a loop of trying to run the update. Always fails at 54% and only thing I can do is remove the battery. If i boot without card it just says it can't find the firmware file. If I boot with the card in then it goes to the firmware update screen and my only option is to select ok and let it try to update again but always fails at 54%.
I used a card that was formatted in the camera. Camera set to P with a full battery in.
Don't know if there's anything I can do to get it out of the loop and restored or if I'm going to have to get it repaired.
Anyone have any suggestions?
Thanks
Andy.