Hello!
Not sure if it's correct section but I will give it a try.
I just tried to install ML for the first time ever. Read installation manuals and etc. and tried to install ML on my Canon 550D. As it said in manual, I had to check my firmware version - I did. It was 1.0.9 as ML need but I still did upgrade firmware (just in case).. Formated card in camera and copied ML install contents to my SD card (Toshiba 16GB). Went to install ML and... got error: could not enable boot flag. Ok, as I read, I should use EOScard if it fails, also reformat SD card on PC first, then once again on camera. Did both. Still get that error.
Any ideas what I do wrong?
And sorry again if it's wrong place,
Thanks in advance.
Not sure if it's correct section but I will give it a try.
I just tried to install ML for the first time ever. Read installation manuals and etc. and tried to install ML on my Canon 550D. As it said in manual, I had to check my firmware version - I did. It was 1.0.9 as ML need but I still did upgrade firmware (just in case).. Formated card in camera and copied ML install contents to my SD card (Toshiba 16GB). Went to install ML and... got error: could not enable boot flag. Ok, as I read, I should use EOScard if it fails, also reformat SD card on PC first, then once again on camera. Did both. Still get that error.
Any ideas what I do wrong?
And sorry again if it's wrong place,
Thanks in advance.