Hi Guys,
I was on holiday recently. Took my 5D mark II with me for taking photos.
The first day I turned it on, everything was fine. Then switched off 'global draw' since I was only shooting stills and don't needed ML at this time.
A few seconds after that the camera display went black. And since that time I am not able to turn it on anymore.
- When I set the switch to 'on', the red led blinks a few times. Sometimes brighter than the other time.
- The display lighting turns on very dimmed but nothing is displayed. If I look closely I can only see a strange pattern grid with lines.
- When I press the shutter I can hear the shutter move, and after that I can hear a bleep. The red LED stays on for a few seconds.
- The camera seems to respond to some buttons such as info, menu, mode dial etc. I know this because it turns the display illumination on and off
- The upper lcd doesn't work
- Using a clean card seems to affect the boot process but still the camera is unusable and shows similar issues as written above.
- EOS utility and Remote shooting recognizes the camera and settings. I can control all settings in remote shooting and release shutter.
I have no clue what to do now. Is this a software issue? If so, can I reset the camera and/or ml installation?
The camera does create LOG files on the CF card, which I included for you guys.
Any help is appreciated!
LOG File: https://www.dropbox.com/s/4lv36gb1ridn6r7/log066.log?dl=0
I was on holiday recently. Took my 5D mark II with me for taking photos.
The first day I turned it on, everything was fine. Then switched off 'global draw' since I was only shooting stills and don't needed ML at this time.
A few seconds after that the camera display went black. And since that time I am not able to turn it on anymore.
- When I set the switch to 'on', the red led blinks a few times. Sometimes brighter than the other time.
- The display lighting turns on very dimmed but nothing is displayed. If I look closely I can only see a strange pattern grid with lines.
- When I press the shutter I can hear the shutter move, and after that I can hear a bleep. The red LED stays on for a few seconds.
- The camera seems to respond to some buttons such as info, menu, mode dial etc. I know this because it turns the display illumination on and off
- The upper lcd doesn't work
- Using a clean card seems to affect the boot process but still the camera is unusable and shows similar issues as written above.
- EOS utility and Remote shooting recognizes the camera and settings. I can control all settings in remote shooting and release shutter.
I have no clue what to do now. Is this a software issue? If so, can I reset the camera and/or ml installation?
The camera does create LOG files on the CF card, which I included for you guys.
Any help is appreciated!
LOG File: https://www.dropbox.com/s/4lv36gb1ridn6r7/log066.log?dl=0