I have a 5DIII v1.2.3 running the last build of ML for this firmware.
I can shoot continuous 24 fps at 1920X1080 but cannot seem to get up to continuous 30. I was using a Lexar 32 GB 1000x card and seeing mid-80's MB for the benchmark test. I stopped at B&H today and purchased a Lexar 64 GB 1066x hoping this would give me the boost I needed to get up to 30 fps. This card show almost identical results in the benchmark.
I have read hours of forum posts and tried turning on and off a number of settings including: Global Draw always off, Hacked preview, Card Warmup, Buffer Fill, Extra hacks - still no success.
Are some 5DIII's not capable to sustained 30 fps? Do I have bad examples of the Lexar cards? (I don't think so from what I've read on the benchmark thread).
Can someone point this rookie in the right direction? Maybe post the settings that will get me there if it isn't a hardware side problem?
Thanks.
I can shoot continuous 24 fps at 1920X1080 but cannot seem to get up to continuous 30. I was using a Lexar 32 GB 1000x card and seeing mid-80's MB for the benchmark test. I stopped at B&H today and purchased a Lexar 64 GB 1066x hoping this would give me the boost I needed to get up to 30 fps. This card show almost identical results in the benchmark.
I have read hours of forum posts and tried turning on and off a number of settings including: Global Draw always off, Hacked preview, Card Warmup, Buffer Fill, Extra hacks - still no success.
Are some 5DIII's not capable to sustained 30 fps? Do I have bad examples of the Lexar cards? (I don't think so from what I've read on the benchmark thread).
Can someone point this rookie in the right direction? Maybe post the settings that will get me there if it isn't a hardware side problem?
Thanks.