Hey guys,
After some googling and reading the ML forum I still have the following issue:
Just bought a FEELWORLD F6 5.7inch IPS 1080P and want to use it as a field monitor for my canon 5dm3.
I am using the Canon Firmware Version 1.2.3 and latest magic lantern build for RAW recording.
Now I have the funny issue that the video signal always switches back to 480p after a few seconds on the monitor.
If I open up the canon menu on the camera HDMI signal switches to 1080i 50 hz.
When I go back to liveview the signal stays 1080 for a couple of seconds looks great and the goes back to 480p which is unusable...
I played around with mirroring on/off and video mode PAL/NTSC.
I managed to get a 1080 clean signal on the monitor but then I do not see any menus, histograms etc...
Are there any restrictions I need to be aware of?
After some googling and reading the ML forum I still have the following issue:
Just bought a FEELWORLD F6 5.7inch IPS 1080P and want to use it as a field monitor for my canon 5dm3.
I am using the Canon Firmware Version 1.2.3 and latest magic lantern build for RAW recording.
Now I have the funny issue that the video signal always switches back to 480p after a few seconds on the monitor.
If I open up the canon menu on the camera HDMI signal switches to 1080i 50 hz.
When I go back to liveview the signal stays 1080 for a couple of seconds looks great and the goes back to 480p which is unusable...
I played around with mirroring on/off and video mode PAL/NTSC.
I managed to get a 1080 clean signal on the monitor but then I do not see any menus, histograms etc...
Are there any restrictions I need to be aware of?