I cannot install ML on my 60D. I tried following the installation instructions religiously but it is not working for me. Some of the details.
Firmware 1.1.1
Reset to default camera settings.
Manual mode
New formatted 32 G card
ML 2.3
Splash screen starts and goes off. Red light blinks slowly and for as long as 15 minutes.
I remove the battery but the camera does not reboot.
A reformatted card allows the camera to boot properly.
Any ideas?
Firmware 1.1.1
Reset to default camera settings.
Manual mode
New formatted 32 G card
ML 2.3
Splash screen starts and goes off. Red light blinks slowly and for as long as 15 minutes.
I remove the battery but the camera does not reboot.
A reformatted card allows the camera to boot properly.
Any ideas?