Malcolm, I misread your post. The camera was already at 1.1.1 so I did not rerun it. Should I have?
- Welcome to Magic Lantern Forum.
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Duplicate Questions / Re: Need help installing on 60D
January 28, 2014, 08:12:47 PM
Malcolm, I did run the firmware update and as so as it starts, a splash screen comes up but disappears before I can read it. I could look at it more carefully. Something must be writing back and forth because I have to reformat the card in my pc to get the camera to boot.
#3
Duplicate Questions / Need help installing on 60D
January 28, 2014, 07:09:40 PM
I cannot install ML on my 60D. I tried following the installation instructions religiously but it is not working for me. Some of the details.
Firmware 1.1.1
Reset to default camera settings.
Manual mode
New formatted 32 G card
ML 2.3
Splash screen starts and goes off. Red light blinks slowly and for as long as 15 minutes.
I remove the battery but the camera does not reboot.
A reformatted card allows the camera to boot properly.
Any ideas?
Firmware 1.1.1
Reset to default camera settings.
Manual mode
New formatted 32 G card
ML 2.3
Splash screen starts and goes off. Red light blinks slowly and for as long as 15 minutes.
I remove the battery but the camera does not reboot.
A reformatted card allows the camera to boot properly.
Any ideas?
Pages1