Messages

thanks for the reply. I am shooting on a Canon 5D MKIII at 1920x1080 at 30fps. I installed the nightly build and it still seems to start skipping frames around 260 frames in. Also I am not sure if I am doing something else wrong but the RAw2dng file does not seem to be converting files now that I installed the nightly build. I am going to search through the forums more and see if I can not find the fix.

However the frame skipping has me stumped. I have two Lexar 32gb 1000x cf cards and have tried both of them. They both seem to do the exact same thing. Is there some way to test the speed of the cards? Could I possibly have defective cards?

I have the nightly build working however it seems to still shut off after just about 0:04 seconds.

I did try that. The most recent nightly build is showing an error on the camera that says retry when installing the new firmware.

Hi all

So today I decided to make the plundge into RAW recording. I have got everything running... or so I thought.

While shooting test footage I noticed as it was recording it showed the expected frames well over 300 an continued growing. However no matter what I seemed to do the firmware forced it to stop recording after 260 frames and no more than 268 frames.

I have searched for hours on the forums and still cant find anything to answer my question.

Here is technical info on the build I have installed.

Build is from August downloaded here: http://www.cinema5d.com/news/?p=17898 (August 21nd files)

I am using a Lexar 1000x 32gb card. I have two and both cards do the same thing.

Any ideas??

I am stumped XD