it is set to off!
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: tobiascorts on July 27, 2014, 08:43:25 PM
hello all,
I am a long time user of magic lantern. was shooting a lot over the last year with the 1.1.3 version of raw.
now I updated to 1.2.3 and everything looked fine so far.
today I rigged the markIII with my tv-logic58 monitor via hdmi for the first time. all tests before were done without the use of the hdmi-out.
it is now not possible to record longer clips than 1min in mlv 1920:1080 25p mode. icon always stays red or yellow. the build is from 16th of july.
as soon as I disconnect the hdmi everything goes green and fine! what does the performance have to do with the hdmi out?
did I set up something wrong somewhere? checked everything, can`t think of anything?!?
thank you so much for every help! i have an upcoming job tomorrow and if I don`t find a solution I have to shoot in h264;-(
tobi
next step was a total reset of the camera including magic lantern build 07.16.2014. supposedly stable.
same problem, no clips longer than 1min, though camera icon turns green now, before it stops due to frame skipping.
am clueless!!
only thing I can think of right now is that my new monitor, the TVLogic 58 needs more process power than my old one the TVLogic 56. Is that possible? Without HDMI no problem at all!
Am I right here in this forum by the way?!?
Page created in 0.072 seconds with 14 queries.