Messages

There is no random freezing as long as you follow the bold advice from the install guide.

Sweet, is there a "tip" for the boot time as well? 

Since you didn't get it. The BOOTDISK flag it is the only thing that ML stores on your camera. To disable it you need to run the installer then turn the mode dial when instructed.... 

Thanks! Now when my blood preasure is lower and I understand english again..

But seriously 3sek boot time and a camera that appered bricked, until i took out the battery a couple of times.
ML has some real cool features, but until the boot time and the random freezing is sorted I pass.

Thanks again, alvess

At 0:45

Very funny, but I'am not up to jokes right now. 

I want the below screen from this page: http://wiki.magiclantern.fm/install


Is it possible or can't ML be uninstalled from the camera as advertised?

Or is this information wrong?

Don't just delete the Magic Lantern files from the card! If you do, the camera will freeze at startup and you'll have to take the battery out.
Uninstalling ML from one card
-Format that card from the camera (select this option: Format card, remove Magic Lantern) and reboot. Your camera will load the original firmware when you use that card.
Uninstalling ML from the camera
-With a Magic Lantern card, launch the Firmware Update process and follow the instructions on-screen.
    Re-installing Canon firmware will not remove Magic Lantern.

Br alvess

Don't skip this step

I have recorded a video where i try to uninstall ML, according to these instuctions:
Uninstalling ML from the camera
-With a Magic Lantern card, launch the Firmware Update process and follow the instructions on-screen.

Here is my video, it don't uninstall and it's no instructions on the screen 

http://youtu.be/XWEtmfa2EbA

Please advice...

[(Don't take my word for it)]

I'm not sure but for me.
I just go to.

Menu/Format/Press Q, Then it will say (Format card, keep magic lantern [Q]) keep pressing [Q] until it says (Format card, remove magic lantern [Q])
Say yes.
Done.

But this is for the 60D has well as a SDHC card.
(Don't take my word for it)

Thanks but according to the "manual" this only removes ML from the memory card, i want it off the camera. 

Don't skip this step

There are none, only succses magic latern is installed.
What am i missing?

Should the camera be booted in any special mode?

Please help, i need my camera as it was.
The boot time with ML is 3sek, even from sleep.
Nice features but boot time is more important to me.

Br alvess

Need help, how to uninstall? (5D mark2)
The instructions don't work:

    With a Magic Lantern card, launch the Firmware Update process and follow the instructions on-screen.
    Re-installing Canon firmware will not remove Magic Lantern.

The above only installs the magic firmware again....

Please help.