Hi,
I followed the instructions on the PDF but the ML installation just does not work.
My complete setup is : Canon Rebel T3i (600D), Firmware 1.0.2, 64GB SDXC (transcend).
I tried the following steps a few times without success :
Thanks for your help!
I followed the instructions on the PDF but the ML installation just does not work.
My complete setup is : Canon Rebel T3i (600D), Firmware 1.0.2, 64GB SDXC (transcend).
I tried the following steps a few times without success :
- Checked firmware: 1.0.2
- Low formatted my SD card from the camera (yes ticked the box)
- Copied the entire content of ML 2.3 zip to the SD card root
- Eject the SD card from my W8
- Put the SD card to my camera
- Turned it back ON
- Went to Menu > Last tool icon > Firmware Ver 1.0.2 > Update : OK
Thanks for your help!