It's not in the ML folder. The instructions say to copy the "ML files." Imo that leaves reason for doubt, so I asked since I don't want to brick my dang camera. Thanks side helping of snark.
- Welcome to Magic Lantern Forum.
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Camera-specific Development / Re: Canon 700D / T5i
September 28, 2014, 08:21:53 PM
Sure, but the info is pretty basic and there is nothing that references the .bin file...so I assume I don't copy it to the sd card?
#3
Camera-specific Development / Re: Canon 700D / T5i
September 28, 2014, 08:03:48 PM
Total newb. Just found this site yesterday. Very excited about what I've read of magic lantern so far.
The ML nightly build install for the t5i seems pretty straight forward but I do not want to brick my camera.
I updated to 1.1.3 yesterday. Downloaded newest nightly build. Unzipped the .fir file to my camera formatted 64GB sd card.
So now do I also need to unzip the ML folder to the sd card too? And then go through the same steps I did to install 1.1.3? Lastly, there is also an autoexec.bin file that downloaded with the NB. Is that file also unzipped to the sd card?
Sorry if these are dumb questions. I REALLY want to do this right. Thanks.
The ML nightly build install for the t5i seems pretty straight forward but I do not want to brick my camera.
I updated to 1.1.3 yesterday. Downloaded newest nightly build. Unzipped the .fir file to my camera formatted 64GB sd card.
So now do I also need to unzip the ML folder to the sd card too? And then go through the same steps I did to install 1.1.3? Lastly, there is also an autoexec.bin file that downloaded with the NB. Is that file also unzipped to the sd card?
Sorry if these are dumb questions. I REALLY want to do this right. Thanks.
Pages1