Messages

Just a quick reply regarding to my problem: I bought a new CF card, a Lexar Professional 16GB 1066x. Now it works like a charm!
I thinks it's an issue with old CF cards perhaps. My Scandisk is 6 years old ...

Thanks for the useful help =)

ok none of my friends uses a CF. So I would have to buy a new card. Is this a ScanDisk problem, should I buy a Lexar instead? - what if ML doesn't work either with the new card?

greetings

yep nothing happens after pressing any button. I don't  have a spare card.

ok I used EOScard enabling EOS_DEVELOP and BOOTDISK.
Wiped the data and extracted it back again. After inserting the card and turning it on nothing happens. Just a black screen.

My card is a SanDisk Extreme Compact Flash 16GB 60MB/S.
contents of card's root: http://fs5.directupload.net/images/160118/2qjjvfa6.jpg

ok I followed your steps and end up in getting this error egain: http://fs5.directupload.net/images/160118/n8pws8cy.jpg when I try to run the update process.

Hi there,

I have some problems installing ML on my 7D 2.0.3 .  After a successful installation of ML a text message instructs me to restart my camera. I wait till the power is off. After restarting the cam nothing happens. After switching the power button from off to on there is neither a red blinking LED nor an active display. It's just a black screen. No key is detected if pressing it.

What I did so far:
a) format the CF in the camera
b) deleted all my custom preferences
c) set the camera mode to M
d) tried several builds:
-magiclantern-Nightly.2016Jan14.7D203
- magiclantern-Nightly.2015Dec20.7D203
e) I took out the battery for several minutes and pluged it in again

I reflashed the firmware to 2.0.5 and back to 2.0.3 and did the same procedure starting with a) - had no effect...
My camera restarts after releasing the battery for seconds and formatting the CF-card.

Sometimes I got this error when trying to install directly from the card: http://fs5.directupload.net/images/160118/n8pws8cy.jpg.
Installation works fine, if I copy the folders and autoexec manually and start the Update through the EOS Utility. But after restart > black screen

Are there any advices?