Hi,
I'm in the process of installing Magic Lantern on my T2i. Before I did I made sure to upgrade to 1.0.9 Firmware. After doing so, when I press the shutter button even just a little bit the shutter fires ( a picture isn't taken) but then when i take a picture the same sound fires again and a photos is taken.
Simply put, when taking a photo the shutter sound fires both when 1/2 pressed and when the photo is captured.
Has anyone else run into this? Again magic lantern isn't on the camera yet.
If anyone has any tips on where to find 1.0.8 so that I may down grade that information would be helpful too.
Thanks
Kristi
I'm in the process of installing Magic Lantern on my T2i. Before I did I made sure to upgrade to 1.0.9 Firmware. After doing so, when I press the shutter button even just a little bit the shutter fires ( a picture isn't taken) but then when i take a picture the same sound fires again and a photos is taken.
Simply put, when taking a photo the shutter sound fires both when 1/2 pressed and when the photo is captured.
Has anyone else run into this? Again magic lantern isn't on the camera yet.
If anyone has any tips on where to find 1.0.8 so that I may down grade that information would be helpful too.
Thanks
Kristi