So after a couple of months...without using any ML at all in my 5D M2, I decided to give it a try once again.
So I installed ML into an old card, then I did the same in the two 16gb 1000x lexars and...trying, again and again, pulling out battery, trying to update firmware , etc...It worked.
But I have some issues.
1.-Takes long to boot sometimes, perhaps 3 to 4 seconds...sometimes is faster than that
2.-Sometimes the mirror stays up and locks so I have to take battery out
3.-I can take photos and then suddenly, I goes crazy, the mirror goes up and down so fast as if it were taking photos real fast
4.-Last time, I turned of and the lcd display stayed on...until I removed the battery.
Its annoying since, its not reliable, even when must of the time I can use it without problem...
When using an 800X lexar, nothing happens, everything is just fine..
If anyone has an idea of what prolem is causing this, I would appreciate your help, ML has been a great tool in my 5D M2
So I installed ML into an old card, then I did the same in the two 16gb 1000x lexars and...trying, again and again, pulling out battery, trying to update firmware , etc...It worked.
But I have some issues.
1.-Takes long to boot sometimes, perhaps 3 to 4 seconds...sometimes is faster than that
2.-Sometimes the mirror stays up and locks so I have to take battery out
3.-I can take photos and then suddenly, I goes crazy, the mirror goes up and down so fast as if it were taking photos real fast
4.-Last time, I turned of and the lcd display stayed on...until I removed the battery.
Its annoying since, its not reliable, even when must of the time I can use it without problem...
When using an 800X lexar, nothing happens, everything is just fine..
If anyone has an idea of what prolem is causing this, I would appreciate your help, ML has been a great tool in my 5D M2