If it's not there it's not there.
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: beauchampy on April 18, 2017, 03:42:37 PM
When you say "cinematographer", do you mean someone who works on feature films?
I think we're mostly in the "videographer / filmmaker" category here. It is a forum for a hacked DSLR after all!
Quote from: stephaud on March 20, 2017, 06:49:56 PM
Hi !
Could you suggest me a good choice for an external monitor working with ML please (hdmi In/Out, 7", focus peaking, 1:1 pixel, histogram...) ?
Thanks !
Quote from: gbk on March 13, 2017, 06:29:12 PM
Every time when I take a photo I've got "raw error falling back to yuv overlays". Why?
Quote from: xsghost on December 27, 2016, 05:16:07 PM
Hi, guys.
Can you tell me if there's any benefit to upgrading to the new 1.1.2 firmware?
I mean besides fixing the Lens aberration correction issue with those two EF-S lenses described in the release.
Quote from: biggles on October 18, 2016, 12:59:23 PM
Hello, I am selling a 500D with ML v2.3 on it, and I want to put it back to default factory settings first, including turning off the boot flag.
I've read the FAQ and Install Guide, and I have some questions about the procedure...
1. Do I need to run the Clear settings menu command first before uninstalling? It says to do before installing, but doesn't say whether to do it before uninstalling.
2. It seems if I want to uninstall ML from the camera (turn off the boot flag again), I need to leave ML on the card and then run the Canon Firmware update from the menu. Does that process *also* format the card to remove ML from the card, or do I need to do that as a next step by doing the Format card -> Remove ML option? The guide isn't 100% clear. If I have to do the Format card option myself, do I do it immediately after running the Canon Firmware update process to remove ML from the camera, or do I reboot (turn off and back on) first?
3. Do I need to use the EOSCard utility at all?
4. How do I know afterwards that the boot flag is turned off correctly, and that the camera is fully back to factory defaults - is there any way to check?
Thank you.
Quote from: Marc_Petzold on June 25, 2016, 01:21:57 PM
but the message are clear.
Quote from: Marc_Petzold on June 24, 2016, 11:10:31 PM
The minimal requirment is that what the 60d does. thats athletic but it is a gate, goal what ever you mean.
Say what you want , and you get what you need.
Quote from: nikfreak on May 17, 2016, 02:29:41 PM
Frarike did you also use lua when your problem appeared?
Page created in 0.096 seconds with 14 queries.