« previous next »
Pages: [1]

Author Topic: Blue light and nothing else  (Read 1932 times)

jrc323

  • New to the forum
  • *
  • Posts: 2
Blue light and nothing else
« on: October 16, 2013, 09:13:02 AM »
I just installed ML tonight and it went through. I went through menu and set what I want out of my 5D Mk2. Then, I see blue light on with nothing on LCD. I may have done something wrong. I am hoping there is a solution to the problem. Thanks in advance for any input.
Logged

ItsMeLenny

  • Hero Member
  • *****
  • Posts: 930
  • 550D
Re: Blue light and nothing else
« Reply #1 on: October 16, 2013, 11:45:18 AM »
Did you try putting a card in that doesn't have ML.
You have to try different things because you haven't provided enough information.
Logged

jrc323

  • New to the forum
  • *
  • Posts: 2
Re: Blue light and nothing else
« Reply #2 on: October 16, 2013, 11:25:27 PM »
I put in other card and it was fine. But then, I put in the card that I used to feed ML and same blue light and blank LCD. I believe I did press something in the setting that caused the ML to go blank. I did move the dial. Only CA showed, but it was nothing. I want to go back to default, but I'm not too sure about the CF card itself.
Logged

ItsMeLenny

  • Hero Member
  • *****
  • Posts: 930
  • 550D
Re: Blue light and nothing else
« Reply #3 on: October 17, 2013, 03:11:53 AM »
Do you have all of the ML folders and the autoexec.bin file on your card.
Logged
Pages: [1]
« previous next »