Need help on firmware reinstallation.

[wts3849]

Hi, thank you very much for developing such a great firmware.

I have a problem with my 5d iii that everytime I turn off the power and turn back on, ML won't boot. This issues seems to have been addressed before but I can not find the thread.

Even for the small capacity cf, once turned off after installation, the bootflag does not seem to recognize ML when turned back on.

I tried with 256mb cf, 512mb cf, 64gb udma6 cf, 32gb sdxc sd. And of course, for the 64gb and 32gb sdxc, I saved autoexec.bin with EOScard utility after installation with the small (256mb or 512mb cf) card.

I haven't had such problem with my 5d ii in the past.

Any comments will be greatly appreciated. Thanks again.

[1%]

Install the dev kit if you don't want to load it every time. The alphas are set up like this.

[wts3849]

Now I see what I was missing. I didn't know alphas are built that way. Thank you very much for your reply. And thanks again to those who contributes time and effort for the greatest firmware.