Hi.
I've tried finding help on ML raw eos M-group on facebook with no luck. Im running Danne's latest build (March 2nd).
At first this was my problem:
Problem is, i cant record in any modes/resolutions more than a few seconds, and then the camera stops recording and says "movie recording stopped automatically. Flushing buffer... [ x ] frames left". This was when data rate maxed out at 21 mb/s.
Update:
Now i somehow succeeded in getting the data rate to 41 mb/s in all overclocking settings - even when overclocking is turned of. Is diffucult to say if there is a logic behind when i get rates of 42 compared to 21. Settings are the same, but the order in which i change the settings are different.
But i can consistently get rates of 42 when i use the built-in presets. But i have never managed to get above 42 mb/s.
For the record: I've set global draw to "off" when i benchmark, and still get the same results.
I have also benchmarked with both raw set to "off" and "on" and got the same results.
I've tried different sd cards (all extreme pro 95 mb/s) with the same result - and i've run benchmarks several times on the sd card with different settings + I've run benchmarks on the sd card through a crappy sd reader on my mac, and that says 79 MB/s write.
I've reinstalled both the 2.0.2 firmware and Danne's build several times.
I've been thinking: Could this be the battery that provide a too low voltage for the camera? Its an original canon battery, but i dont know how old it is.
Fyi: I've just bought the camera and recieved it 2 days ago. And i havent got any other power options for it yet.
What do i do?