Canon 550D boot flag

[minilock]

Hello!

Not sure if it's correct section but I will give it a try.

I just tried to install ML for the first time ever. Read installation manuals and etc. and tried to install ML on my Canon 550D. As it said in manual, I had to check my firmware version - I did. It was 1.0.9 as ML need but I still did upgrade firmware (just in case).. Formated card in camera and copied ML install contents to my SD card (Toshiba 16GB). Went to install ML and... got error: could not enable boot flag. Ok, as I read, I should use EOScard if it fails, also reformat SD card on PC first, then once again on camera. Did both. Still get that error.

Any ideas what I do wrong?

And sorry again if it's wrong place,
Thanks in advance.

[Walter Schulz]

http://www.magiclantern.fm/forum/index.php?topic=15403.msg150165;topicseen#msg150165

[minilock]

Thank you very much! Works now.