« previous next »
Pages: [1]

Author Topic: Need help installing on 60D  (Read 1952 times)

JoePhoto

  • New to the forum
  • *
  • Posts: 3
Need help installing on 60D
« on: January 28, 2014, 07:09:40 PM »
I cannot install ML on my 60D.  I tried following the installation instructions religiously but it is not working for me.  Some of the details.

Firmware 1.1.1
Reset to default camera settings.
Manual mode
New formatted 32 G card
ML 2.3
Splash screen starts and goes off.  Red light blinks slowly and for as long as 15 minutes.
I remove the battery but the camera does not reboot. 
A reformatted card allows the camera to boot properly.

Any ideas?
Logged

Malcolm Debono

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 707
  • Cinematographer
Re: Need help installing on 60D
« Reply #1 on: January 28, 2014, 07:25:30 PM »
Did you run firmware update on camera when you place ML files on SD card?
Logged
Wedding & event cinematographer
C100 & 6D shooter
New here?  Check out the FAQs here!

JoePhoto

  • New to the forum
  • *
  • Posts: 3
Re: Need help installing on 60D
« Reply #2 on: January 28, 2014, 08:12:47 PM »
Malcolm, I did run the firmware update and as so as it starts, a splash screen comes up but disappears before I can read it.  I could look at it more carefully.  Something must be writing back and forth because I have to reformat the card in my pc to get the camera to boot.
Logged

JoePhoto

  • New to the forum
  • *
  • Posts: 3
Re: Need help installing on 60D
« Reply #3 on: January 28, 2014, 08:57:14 PM »
Malcolm, I misread your post.  The camera was already at 1.1.1 so I did not rerun it.  Should I have?
Logged
Pages: [1]
« previous next »