Is there MLV pixel maps out for the 5kfrtp mode Yet? Just shot some stuff but realized the built in focus pixel removing tool wasn't having an effect. My resolution is 1120x1890, should I post a framegrab fo you guys?
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: ZEEK on October 06, 2020, 03:09:51 AMThanks Zeek! Love your work, keep it up!
I use a 512GB SD Card and have recorded 100 Minutes (1hr 40min) with Magic Lantern Raw 1080 Mode, and could have recorded way more. So if you're not shooting RAW, you're definitely fine.
Quote from: Mythic Cinema on October 04, 2020, 10:17:27 PM
You are only shooting 2 hours with 3 EOS M cameras. I would be using raw your case, where as I shoot with 4 cameras for 8 to 10 hours and that is when raw is too much data. In your case all you need is three 256gb SanDisk Extreme Pro cards, which will fill about 204GB on each card give or take, for 1080p Raw at 2 hours. Not bad at all. You are lucky. I wish I could use raw in my case. Run a test in raw and see how long you get until your card runs out, then do the calculations. It should be under 256gb for 2 hours @ 1080p.
Quote from: Danne on July 07, 2020, 08:02:37 AMSure
I uploaded a new build. Could you test for corruption in 16fps in that version?
https://www.magiclantern.fm/forum/index.php?topic=9741.msg208959#msg208959
Quote from: DeafEyeJedi on June 10, 2020, 12:26:48 AM
Could you clarify what "drop-out" means to be exact?
Indeed, both black 95MBs & 170MBs have been remarkable thus far @Kgncom!
Quote from: Danne on June 09, 2020, 11:49:38 PM
Use the black ones. 95mb or 170mb.
Quote from: Walter Schulz on June 09, 2020, 02:38:12 PM
Not taking shots with adapter mounted:
C.Fn IV 7:
Lexar Pro 1000x is an UHS-II card. This card will run in UHS-I compatibility mode. I can only recommend not to use it.
Lockups: Most likely you took a card which was prepared for ML (= bootable) and wiped autoexec.bin. Cam will lockup and FAQ/Install Guide will tell you not to delete autoexec.bin!
Page created in 0.105 seconds with 13 queries.