8
« on: September 18, 2018, 12:11:51 PM »
Hi,
I have spent ages trying to fully understand the options for getting the highest quality, and have these settings so far, that seem to give continuous recording.
The first thing is that the Sandisk Extreme card I have gives around 49mb write speed when I test it with Blackmagic Speed Disk, however, in the camera is only giving around 23mb.
I am running the 4k experimental build, with the following modules loaded:
crop_rec
mlv_lite
mlv_snd
raw_twk
As for settings, as follows:
FPS Overide 23.976, optimised for exact FPS
movie crop mode OFF
crop mode OFF
Raw Video 1568x882 @11/14bit Lossless
If I want to zoom in, I turn on the Movie Crop Mode and also the Crop Mode.
I have the display set to the 3 info setting, as I use manual focus with green lines to show where the focus is.
There are some problems, when stopping recording sometimes the camera seems to hang and I have to turn off and on again.
The resolution was found by trial and error, as to which gave the highest value. I also tested whether recording the sound or not, allowed a higher capture res, but it didn't.
I then process the files with Switch, using the default settings and then use Resolve to edit/ colour / grade.
Is it possible to get some advice/pointers on my setup please, and whether anything I am doing is wrong.
thanks,
Simon.
EDIT:
Just installed the firmware linked a few pages back.
Now I can record at 1712x964 @23.976
The problem is that I have to be on the first of the info screens, to get a green record.
If I go to the one I want to use, the 3rd as it shows focus lines, the speed drops and I am unable to record.