Quote from: Walter Schulz on May 23, 2014, 09:50:30 PM
You missed:
- Make card bootable.
Back to start. Read installation manual.
Worked! Thanks. (:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Walter Schulz on May 23, 2014, 09:50:30 PM
You missed:
- Make card bootable.
Back to start. Read installation manual.
Quote from: lister on May 31, 2013, 02:55:13 PM
Hello to everyone.
I have to report two issues with all nightly builds i have tried and 600d that are not happening with version v2.3.
First, camera wakes itself from standby power save mode without touching any buttons. That happens quite regularly, few seconds to few minutes after it turns off screen and sensor.
Second problem is bigger. Recording stops automatically after few seconds or few minutes. I have restart option turned on so it restarts automatically. This happens approximately once in every 20 recordings. It was happening always after few seconds, but with the last nightly build (May 30) it started to happen after one or two minutes also. It is a big problem and it could ruin some important shots... I have Sandisk class 10 cards. It never happens with 2.3. with the same card and all the same settings. I also never touch any bitrate controls and i was testing with freshly formatted cards. I really like all audio controls with nightly builds, but for important shootings i have to go to 2.3 : (.
Just to mention, I also use Rode Videomic pro. I fiddle a lot with analog gain and mic boost (not during recording).. It might be connected, who knows.
Page created in 0.068 seconds with 14 queries.