Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - j.diazmeco

#1
Camera-specific Development / Re: Canon EOS M
November 11, 2015, 04:06:11 PM
Quote from: dfort on November 11, 2015, 03:00:04 AM
A few more improvements that will benefit EOSM users are in the works but the issue that is holding up nightly builds isn't fully resolved yet. Patience.

However, for the impatient who prefer a little more excitement I decided to merge lua into my EOSM__working branch. What the heck, it is very useful and it is a module so if you don't load it you won't even know that it is there. For those that still haven't set up a Magic Lantern development system I uploaded a nightly to my bitbucket download area:

https://bitbucket.org/daniel_fort/magic-lantern/downloads

Check out what you can do with it on the lua topic.
Thanks! I will build it later and give it a look!!
#2
Camera-specific Development / Re: Canon EOS M
November 09, 2015, 08:59:07 AM
Quote from: dfort on November 09, 2015, 01:08:48 AM
I keep adding what seems like interesting pull requests to my EOSM branch so at times it might exhibit some odd behavior. Of course ML in general exhibits some odd behavior. As do ML users--but I don't think there's a fix for that.
Well, that's why I got a canon m, I'm odd...[emoji16]
Thanks for the work.
#3
Camera-specific Development / Re: Canon EOS M
November 08, 2015, 10:57:21 PM
Quote from: dfort on November 06, 2015, 03:35:17 AM
a1ex made some comments on bitbucket that should push the frame rate on the EOSM a bit further.

I'm a bit busy right now to test it but if there are any users who want to see how far they can push their little camera I added it to my EOSM__working branch and also compiled it and uploaded it to my bitbucket download area.

First time here, just got a second hand M in ebay. Compiled from your branch a couple weeks ago, and now downloaded and installed that zip. I noticed smthin, now I can go in CBR further than 3.0x, I think before I could just go up to 3.0x, no more values. ¿Am I right? Anyway no matter the value, when I enable bitrate info it seems to be stuck in q+-1.
Tomorrow will try to make some tests.