It did that before ML installed in both 1.1.3 and 1.1.6. Again, no big deal.
- Welcome to Magic Lantern Forum.
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Camera-specific Development / Re: Canon 6D / Firmware 1.1.6
June 27, 2015, 09:21:24 PM
Yes, I agree. I choose yes/continue and the camera works just fine. I would just be wary of the percentage left. I use the Canon batteries first then keep the other two for "just in case" scenarios.
#3
Camera-specific Development / Re: Canon 6D / Firmware 1.1.6
June 27, 2015, 07:36:26 AM
I tried using 2 different after market batteries, one I don't even know the manufacturer, the other is a Wasabi . . . neither one of them are recognized and each gives me a different message when I power up:
Unknown - "Cannot communicate with battery, Use this battery?"
Wasabi - "Communication with Canon LP-E6/LP-E6N battery is irregular. Continue to use this battery?"
They power the camera if I choose to continue but I'm not sure how correct the battery percentages are. I'll stick with the original OEM Canon batteries just to be safe.
Unknown - "Cannot communicate with battery, Use this battery?"
Wasabi - "Communication with Canon LP-E6/LP-E6N battery is irregular. Continue to use this battery?"
They power the camera if I choose to continue but I'm not sure how correct the battery percentages are. I'll stick with the original OEM Canon batteries just to be safe.
Pages1