Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - MCAN

Pages: [1]
Share Your Videos / Re: Strange Screen on Recording
« on: June 21, 2017, 12:34:00 AM »
Wrong sub friend. Try the General Q&A or Raw sections.

Reverse Engineering / Re: ProcessTwoInTwoOutLosslessPath
« on: April 01, 2017, 05:25:37 PM »
Will there be a custom MLV_DUMP for mac? :)

+1 Please!

Hardware and Accessories / Battery Grip + 5d3 1.1.3 + ML Problems
« on: August 28, 2016, 05:47:19 PM »
Hi all,

I have been encountering an issue while using my ML-equipped 5Dmk3 with a battery grip.

When I first began using the grip, I believe I was using either the January 14 or the April 1, 2016 build of ML. No problems.

When I installed the "experimental" 3x RAW crop firmware from Apr 2, the battery grip stopped working. The camera would not turn on. No indicator light of a battery being installed (red flash in lower right corner) I just figured the grip was broken until I got the idea that the firmware build may the problem. I rolled back to the last working version I had (see above) and the grip worked again!

The grip adds weight obviously so I have had it off for the last few shoots. I last updated to the July 9 build, and today when I tried to use the grip again, the camera would not power on!

I rolled back again, one firmware - nothing - and kept rolling back until I got to the January 14, 2016 build again. Not working. So I said to hell with the grip, re-updated to July 9 (fresh install, ML went through a mini-boot to install settings etc., had to re-do my modified settings) and went back to single battery use. Everything was fine.
Then I thought I would try the grip again. It worked! As soon as I removed it though, and tried to put it back on to make sure it would work, the camera would not power on again.

It's almost as if I need to reset ML and its settings to get the grip to work. It's very frustrating. Has anyone else had this problem? Is it a bug in ML?


Share Your Videos / Re: Exodus Short Film | Shot on 5D3 raw
« on: June 07, 2015, 05:03:17 PM »
Good work!

I love how warm it's graded. Hot and uncomfortable. It works quite well.

How did you get a helicopter shot at the end?

Pages: [1]