Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Guido

Pages: [1]
Timelapse Postprocessing / Re: S-RAW for deflicker?
« on: November 29, 2014, 07:35:44 PM »
Thanks a lot!! I´m getting there  :o

Timelapse Postprocessing / S-RAW for deflicker?
« on: November 28, 2014, 02:48:27 PM »
Hi everybody,

I am just fighting to get my first flickerfree ETTR-timelapse out of my 7d and step by step I ´m getting closer …

It took me a while to find out that the deflicker module only works when I shoot in RAW, but not in the small S- or M-RAW format.

So is there a way to avoid the huge amounts of data and create .xmp files also with the smaller RAW-formats?

Thanks in advance for your support!  :D


Duplicate Questions / Re: 7d without Auto Exporamp?
« on: August 19, 2014, 12:19:01 AM »
Good point  :o

Thanks and greets from the blind  8)

Duplicate Questions / Re: 7d without Auto Exporamp?
« on: August 18, 2014, 12:30:09 PM »
ETTR is a module, you have to load it first. It doesn't show up until you load it (see the module menu like Walter said).

Bulb ramping ("Auto Exporamp LRT Holy Grail" as you call it) is not missing, it was removed a long time ago. AutoETTR + Deflicker is a superior method.

Yes yes yes, I´m coming closer :-D
Found ETTR, thanks a lot!

So when bulb ramping no longer exists, what method do I use for timelapse shoots with big changes from bright to dark??

Duplicate Questions / Re: 7d without Auto Exporamp?
« on: August 15, 2014, 12:54:11 PM »

Well, in the EXPO menu it shows
- White Balance
-Picture Style
-Expo Lock
-Expo Presets
-Expo Override

but no »ETTR« …

And under Intervalometer menue is
- Take a pic ervery…
-Start trigger
-Start after
-Stop after
-Auto ExpoRamp LRT Holy Grail … IS MISSING
-Manual Focus Ramp


Duplicate Questions / 7d without Auto Exporamp?
« on: August 14, 2014, 08:48:42 PM »
Hi everybody,

I just downloaded and installed the latest (?) ML for my 7d here:

Everything works fine except there is no »Auto Exporamp« and no »Auto ETTR«. Do I have to install the »regular« version ML 2.3 for that? Where is my mistake?

Thanks in advance for your support :-)

Pages: [1]