Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Tralfaz

#1
Thanks Hey, for the help on shutting off the camera.

Here are new readings that were taken about 2 minutes apart.  My card filled up so this was as far as I could go.


Canon T1I - 500D

RAW TEMP (celcius)

149         36
159         43
163         49
167         53
168         58
169         61

#2
Not sure how much this will.  These readings were taken on a Canon T1I/500D camera.  The ML raw values stopped at 158 while the exif temperatures continually increased until I got the red flashing thermometer on the display. So, I stopped so I wouldn't damage my camera.  The right side of the camera was hot to the touch as was the SDHC memory card.  I am using the Nightly.2015Jan29.500D111 build.

Canon T1I/500D

RAW TEMP (celcius)

153 35
158 49
158 56
158 63
158 71
#3
Camera-specific Development / Re: Canon 500D / T1i
February 09, 2015, 06:08:15 PM
Thank you Walter.  I had tried searching for 'internal temp' and 'help needed', but didn't find anything like the link you provided.  Even looked in the ML manual.  I didn't realize the 'help needed' was a way to ask for my help for this camera.  I thought it meant I needed to get help for my camera! LOL

Anyway, I am in the process right now of putting together the temp values to post in the other link when everything is done. 

Thanks once again for the quick response.
#4
Camera-specific Development / Re: Canon 500D / T1i
February 09, 2015, 04:52:00 PM
Hope this is the right spot.

Just picked up a used Canon T1I - 500D.  Verified my firmware was 1.1.1 and installed Magic Lantern on it.  While going through the menus checking everything out, it showed the Internal Temp as "157 raw (help needed)".

Does anyone know what this means and is it dangerous for my camera?

Thanks in advance...
Al