Messages

Thank you

1: No. 1680x1080, 60 fps interlaced.
2: U3 is a pretty useless designation. 30 MByte/s isn't sufficient to reach cam's vanilla SD-card interface limit without overclocking: Around 43 MByte/s read, 40-ish write. Something like Sandisk Extreme Pro in the 170/160 MByte/s (as labeled) has given most consistent results with and without overclocking.
3: Nothing to write home about.
4: If you want to go after highest resolution in raw/MLV recording:https://www.magiclantern.fm/forum/index.php?topic=25786.msg234507#msg234507
Read first post (at least) of this thread.

Hello everyone ( sorry I don't speak English I translated for Deepl)
I have a 70D and haven't used the Magic Lanter for about 5 years. Installed today and I was lost lolll
1 - I would like to know if it is already possible to have a completely clean HDMI output, without any black bars to use on a Blackmagic atem mini table.
2- I don't like the original soft image from canon. The RAW image has much more detail than sony alpha. I would like to know if it is already possible to record full hd or near full hd continuous raw. I saw that it has 10/12/14 bit but stopped at maximum 20 seconds even using U3 card.
3 - Is there any recording without sesr RAW that has more detail in the image compared to the original?
4 - Which firmware should I use?