Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ebetecos

#1
I've downloaded the newest one, and there is only autoexec.bin and ML folder. To perform the instalation firmware file is needed, which is not there. If I take the one from stable version, then there is error with fonts.dat. So from this symptoms I assume that there is missing something there, althought I'm not an expert here:)
#2
It worked. Thank You for help.
So as I undesrstand I should extract nightly build over stable release? I assumed that nightly build has everything it needs.
#3
But that is what i'm doing. I'm using autoexec.bin from "nightly build" and ML folder from "nightly build". The only thing i use from 2.3 is firmware to proceed with firmware update.
#4
600D
@nachordez 
That's what i was doing, but then i have this error: fonts.dat not found and installation stops. I have formatted it in cardeader and in camera.
#5
I would like to do that, but i nightly build there is only autoexec and ML folder, so I cannot run firmware update. Previously there was in 2.3v.
#6
OK, maybe I do something wrong.
If I install nightly build , should I have previously update firmware with magic lantern 2.3 and then boot it with card with nightly build prepared with EOScard?
Or should i add firmware file from 2.3 to niglty build and upgrade firmware from canon?
The card is at every step formatted before any new software .
#7
Hi,
I've just tried to install my first nightly build but I have error : no fonts.dat found.
It is build from 08.08.2014, i have extracted file directly to SD from winrar. What is the possible problem here? Thank You for any help.