Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - efbiaye

#1
To asnwer my own question. I had to download a different version of CR2HDR, then the checkboxes appeared  :)
#2
OK, I am lost. I know the parametrs boxes are generated dynamically, but I don't see any checkboxes now. I use the build listed in the 1st post of  cr2hdr thread.
Any help?
#3
Guys, I need your help.

Followed all steps very carefully. I had previously installed ML to 5Dm3 with not problems.

Now, after I updated my 7D witch patched .fir, the led turned RED, stayed for about 15s, then the camera looked as if it was completely off.
Waited couple of minutes - nothing. Turned it to off position, then back to ON, nothing happens.

As if the battery was dead. Completly no reaction...
Is there anything I can do????