Messages

Does this problem is caused by the SD card size (32GB instead of 4GB)?

No.

Is there a way to automatically force the module loading even if the camera was not shut down cleanly?

Debug tab -> Modules debug -> Load modules after crash ON

Top of page -> Downloads -> Download nightly builds -> 5D3.123 and read instructions.

https://builds.magiclantern.fm/#/features -> Audio

I cannot see "really good Reading speeds". It looks like an USB 2.0 connection is in use. Reader is connected to computer's "blue connectors" and USB 3.0 drivers are installed?

The latest stable build is some years old now and no longer supported.
Top of page -> Downloads -> Download nightly builds -> 600D.111
You will find those informations in first post of this thread. It's always a good idea to read the first post in sticky threads.

There is a maintainer for 550D. There is no maintainer for 600D.

You cannot. It was removed because there is some kind of confusion about the sensor's behauviour.

No maintainer -> No thread
http://www.magiclantern.fm/forum/index.php?topic=12113.msg117301#msg117301

Top of page -> Downloads -> Download nightly builds -> 550D.109
Read instructions with care!
You have to install v2.3 first. There is a very detailed installation PDF included in v2.3. Read it!
You will find you cannot use a 64 GB card for first time installation.

Problem *is* on your side.

Top of page -> Downloads -> Download nightly builds -> 5D3.123 and read instruction there.

http://www.filedropper.com/magiclantern-nightly2015may3170d111a

Problem must be on your side. Download again and retry. Just open zip, mark contents and copy marked contents to card.

http://www.magiclantern.fm/forum/index.php?board=52.0
Or use this method:
http://www.magiclantern.fm/forum/index.php?topic=5705.0

Do you have MLV_PLAY.mo and FILE_MAN.mo loaded?

Magic Lantern Forum -> Magic Lantern Releases -> Camera-specific discussion. Read first posts in 5D3 threads.

Downgrading from 1.3.3 needs EOS Utility. Canon made life a little bit more complex for 5D3 owners.

Different processor, different OS and there is no way to run "Firmware Update" on your computer because this option does not exist there.
Error pointing to secondary SATA interface.
Get an USB 3.0 to SATA adapter and connect your secondary disk to your laptop.

This will happen if you're not giving ML enough time to shut down properly.
Shut down, wait for 5 seconds.
Power on cam.
Status?

Top of page -> Downloads -> Nightly builds -> Select the version you need and read instruction.

Have you tried to upgrade to 1.3.3?

Yes, read nightly build instructions ...
=====
What are the disadvantages of nightly builds?

[...]

- No documentation - the only help for new features is a small line of text, and ML source code.
=====

It's ready when it's ready.
There are no timeframes within ML project.

Movie tab -> Movie Tweaks -> REC/STBY notify

Format card in cardreader.
Format card in cam.
Make card bootable using Macboot/EOScard.
Delete all contents from card.
Copy extracted nightly build contents to card.
Insert card into cam and startup.
Report results.

Remove battery, remove card. Remove accessories (if any). Make sure battery is okay.
Insert battery, *don't* insert card, close compartment doors.
Startup cam.
Report results.

http://magiclantern.fm/forum/index.php?topic=7139.0
http://magiclantern.fm/forum/index.php?board=56.0