Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - nomadfilm

#1
Hi Danne,

Thanks for the advice.  With the SD patch off, should I be experiencing a red dot beside one of the memory patch settings (EA39374)?
#2
Hi everyone,

I've been playing around with this build and I've run into a problem.  I was recording using various settings and on a previous start-up, script came up on the screen that scrolled too fast for me to read but included the phrase "Fix me."   Now, there is a red dot beside my Memory patches setting (EA39374) and speed tests show that my write speed has decreased to about 9 mb/s on my SD card.  When I turn on SD overclock, all Memory patch dots go red.  Is this normal/expected or has something gone wrong?  Obviously, I don't understand the Memory patch setting.  I've purchased a new SD card and tried a speed test on it and I get similar results.  I've also done a full re-install and that doesn't seem to fix the situation. I backed up my files and can provide info if needed.  Any help would be greatly appreciated. 

As a followup, has anyone been using card spanning in combination with sd overclock?  Are there any limitations in this setting?

Thanks
#3
Quote from: Danne on January 11, 2021, 07:55:47 PM
I recommend you uninstall any older builds to start clean. Then install next build fresh.

Thanks @Danne for answering such a basic question.  Does a complete reinstall mean formatting the SD card in camera and then moving the ML files for the new build onto the card?  Does there need to be a copy of the firmware on the Sd card for ML to operate it or is this not necessary?  Thanks again for helping us newbies.
#4
Thanks you so much!  I assume that the same applies to all of Danne's 4K build, right?  Again, greatly appreciate the response.
#5
Hi All,

I apologize in advance for the beginner question but I want to confirm the process of upgrading to this build.  Do I simply copy and replace the ML folder and autoexec.bin currently on my SD card with the ones provided in this build?  Just want to make sure before I take the leap.  Thanks in advance for your patience as I continue to learn and explore.
#6
Hi All,

Very basic question here.  I've scoured the forum and I might have just missed it.  I'm looking to move from magic lantern nightly 2018 Jul03 build to crop_rec_4K (5D31.1.3).  The information that I seem to have found suggests that I simply copy and replace the crop_rec_4K ML folder, autoexec.bin and MLsetup.fir onto the SD card.  Is that correct?  If anyone could point me in the direction of a post or resource that would explain the process I would be very grateful.  Many thanks and apologies for the beginner question.