Messages

Would it be possible to completely reset the Camera from outside then? Or would the possibly eraneous MPU config still be active?
This was my last thought on how to reset the camera.

In my experience JTAG debugging is very hard if you don't have control over the debuggee. I used to debug some FPGAs via JTAG and it was always a little bit tricky.

If the reset via USB won't work, I think the camera will find it's way to ebay for spareparts.

[InT-44hex:ff01b088 USBDetectISR 0Hotplug :ff01b278 USB Connect ->->->-> 0]

There is a message on the display

connect:
InT-44hex:ff01b088 USBDetectISR 0
Hotplug :ff01b278 USB Connect ->->->-> 0

disconnect:
InT-44hex:ff01b088 USBDetectISR 0
Hotplug :ff01b298 USB Connect <-<-<-<- 0

It looks like the camera recognizes at least USB connection, but is not shown in device manager

Can you try turning on with CA mode selected (on the mode dial).

Ich tried but it didnt work

Can you try turning on with CA mode selected (on the mode dial).

I'll try when I am back home this evening.

What happens if cam is connected to PC via USB?

This has no effect .

ML version?

Latest Nightly build (2018Jul03.60D111)
Firmware is 1.1.1

Hello,

my EOS 60D isnt starting up. I tried with different Battery and without Card but nothing happens. Whenever I insert a card with ML the red LED is flashing (7 times a "double" flash).
I tried the diagnostic tools and the display test worked as well as the ROM dumper. The only strange thing is, that the ROM files were dumped to the root folder nad not to the ML/LOGS/...

But I can't get the camera working, no matter what I try.

Can anybody help me?

Best regards
Silvio

Hello,

my EOS 60D isnt starting up. I tried with different Battery and without Card but nothing happens. Whenever I insert a card with ML the red LED is flashing (7 times a "double" flash).
I tried the diagnostic tools and the display test worked as well as the ROM dumper. The only strange thing is, that the ROM files were dumped to the root folder nad not to the ML/LOGS/...

But I can't get the camera working, no matter what I try.

Can anybody help me?

Best regards
Silvio