So I actually figured it out after playing around some more and found another video online. The main problem was the horizontal width was fine but the vertical wouldn't fit - but I managed to manually expand it in AE before exporting to premiere.
- Welcome to Magic Lantern Forum.
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Post-processing Workflow / Re: Combining RAW and non-Raw footage in one video in premiere pro
September 12, 2017, 07:36:05 PM #2
Post-processing Workflow / Combining RAW and non-Raw footage in one video in premiere pro
September 11, 2017, 08:45:39 PM
Very very new here, and I'm still trying to figure everything out, so if this has been discussed before please direct me to the proper thread. Here's my problem:
I want to combine shots that I took using different clips that are of different resolutions and frame rates. For example, I have a 60fps Raw clip that I filmed at 1440x368 resolution with an aspect ratio of 2.35:1, that I slowed down to 29.97fps. I want to combine that with non-raw footage that I took at 1080 at 29.97 fps. I am using AfterEffects to render the .dng using the Quicktime and H.264 settings. In Premiere Pro I open a new 1080p sequence and import both clips. Even though I click on scale to frame size with the raw clip it still doesn't match the frame size of the already 1080 clip, and I can't get the heights to match up. Any suggestions? I'm using 600D/T3i.
I want to combine shots that I took using different clips that are of different resolutions and frame rates. For example, I have a 60fps Raw clip that I filmed at 1440x368 resolution with an aspect ratio of 2.35:1, that I slowed down to 29.97fps. I want to combine that with non-raw footage that I took at 1080 at 29.97 fps. I am using AfterEffects to render the .dng using the Quicktime and H.264 settings. In Premiere Pro I open a new 1080p sequence and import both clips. Even though I click on scale to frame size with the raw clip it still doesn't match the frame size of the already 1080 clip, and I can't get the heights to match up. Any suggestions? I'm using 600D/T3i.
Pages1